22W MOSFET WM-333 Stereo Audio Sound Amplifier

Attention: This article includes a cable to connect the amplifier directly to an arcade power supply. If you are going to connect it to a power outlet you should buy a 12V 3A power supply like the one we sell in this LINK.

Enjoy the best 8/16 bit sound thanks to this sound amplifier that will allow you to connect 4-8 ohms / 22 watts maximum speakers and give that last touch to your Arcade Machine, Bartop, or similar Arcade Project.

This MOSFET WM333 audio amplifier has a Philips amplifier chip making the sound quality extremely good.

This Audio Amplifier is powered by 12V / 2A and allows the volume to be adjusted through a small knob on the front.  You can also adjust the bass and the balance of the speakers. You'll enjoy the Arcade sound as if you were in a night club invited by DJs Mario and Luigi.

This amplifier has both Stereo and Mono functionality, a must if you own an original arcade machine with a single speaker.

A cable is also included in the package to allow you to connect the amplifier directly to an arcade power supply.

Features

• 22W / 8 ohm
• Stereo sound amplifier 
• 2 X RCA Inputs
• 2 X Inputs for Speakers
• Mono and Stereo functionality
• Power supply 12V / 2A (cable included for Arcade PSU)
• Volume is adjustable thanks to a small regulator on the front side
• Adjustable low and high boost
• Adjustable right-left balance
• 20Hz - 20kHz Frequency
• Philips branded amplifier chip
• S/N Ratio: 80dB