LED JST cable with 16 x 6.3mm connections for Zero Delay Encoder 5V

Using this 16-connection wiring you can connect your LED push buttons to the Zero Delay board to illuminate them without the need for an external power supply or voltage. To do this you must connect them to the Zero Delay board integrated with 2 5V+ connectors since there are 2 versions of the same board. You can find the compatible board with this wiring HERE. As you can see, it is identical to the standard Zero Delay board with the difference that it has 2 red 5V+ voltage connectors.

With each set of cables, you buy, you can connect up to 16 push buttons. If you wanted to light up 32  LED buttons for example, you would need 2 units of this same cable. This is the maximum number of push buttons that can be illuminated with 1 Zero Delay board. However, 16 push buttons per player is more than acceptable for most Arcade and Games Machines projects.

This LED wiring consists of 1 cable with 16 ground connections (black wire), 16 connections with voltage (red wire) and 1 JST type connector. The 5V+ provided by the board, is sufficient voltage for the push buttons to have good illumination. In addition, with these cables you can also connect an illuminated LED joystick. The wiring has an approximate length of 28cm.

Features

• JST cables to illuminate up to 16 LED push buttons
• 5V+ voltage
• Easy installation
• 6.3mm fastons
• Quality Thick Cables 
• 28cm long wiring
• Compatible with Zero Delay 5V+